It's not the smallest micro PLC, but it will put the biggest
smile on your face!
DirectLOGIC 105 Micro Programmable Logic
Controller
- 10 inputs and eight outputs
- 2 K program memory
- 384 words data memory
- 91-instruction programming includes time or event-based drum
sequencer, timed interrupt, immediate I/O, etc.
- 7 amp relay outputs
- One RS-232C communication port
- Removable terminal connectors
- Eight I/O configurations
- 110/ 220 VAC or 24 VDC power supply versions
- Built-in 24 VDC auxiliary power supply for field devices
- One RS-232C communication port
- DeviceNET slave I/O blocks
DeviceNET slaves offer affordable I/O nodes
Connect these DeviceNET slaves (F1-DVNET models) to any DeviceNET
master for inexpensive nodes of I/O in the following configurations:
DC in/Relay out, AC in/Relay out, and DC in/DC out. You get all the
same macro I/O features - powerful relays, high-speed I/O modes,
plus a built-in RS232 communications port for ASCII device
interface. |
|
Use the DL105 micro PLC
to:
- Build an electronic drum sequencer with 18 I/O and connect an
operator interface without paying a high price
- Drive high-current (up to seven amps) loads with the AC/ relay
model
- Use the high-speed I/O modes of a DC input or output model to
perform counting or positioning tasks
NOTES: New option
modules may not be supported by CPUs purchased prior to the modules
release.
Be sure to check for the latest firmware for your PLC.
You can refer to the module specification page on our Web site for
this information, or find it in our free catalog.
Here is the
direct link to the Firmware Upgrade section of our Web site where
you can find the firmware revision histories, the latest files and
tools required to download the firmware into your CPU.
|
